недоступно на русском языке

Тезис

 Preview

This document specifies procedures to measure the bending resistance of paper and paperboard using a Taber-type tester.

This document is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.

The method is primarily used for papers with a high grammage.

NOTE This document does not cover the low-range version of the Taber-type instrument that uses a bending length of 10 mm (see Reference [5]).


Общая информация 

  • Текущий статус
     : Опубликовано
    Дата публикации
     : 2020-02
  • Версия
     : 2
  • Технический комитет
     : ISO/TC 6/SC 2 Test methods and quality specifications for paper and board
  • ICS
     :
    85.060 Paper and board

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF61

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 85
  6. 85.060
  7. ISO 2493-2:2020