ISO 6162-1:2012
p
ISO 6162-1:2012
52096
недоступно на русском языке

Текущий статус : Опубликовано (Будет пересмотрено)

Последний раз этот стандарт был пересмотрен в  2023. Поэтому данная версия остается актуальной
Это стандарт будет замененоISO/AWI 6162-1
ru
Формат Язык
std 1 129 PDF + ePub
std 2 129 Бумажный
  • CHF129
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO 6162-1:2012 gives general and dimensional specifications for flanged heads, split flange clamps (FCS and FCSM), one-piece flange clamps (FC and FCM), ports and mounting surfaces applicable to four-screw, split and one-piece flange clamp type tube connectors and hose fittings for use at pressures of 3,5 MPa (35 bar ) to 35 MPa (350 bar). It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals.

ISO 6162-1:2012 also recognizes the need to accommodate metric screw fasteners (type 1), as well as to provide a means to use existing inch screw fasteners (type 2).

These connections are intended for application in hydraulic systems on industrial and commercial products where it is desired to avoid the use of threaded connectors.

Surges of pressure higher than the nominal ratings will reduce the ability of the flange connections to retain the hydraulic fluid. This needs to be taken into account in the design of the hydraulic system.

Preview 

Вы можете ознакомиться с данным стандартом в нашей онлайн-библиотеке (OBP)

Общая информация

  •  : Опубликовано
     : 2012-12
    : Между-народный стандарт подлежит пересмотру [90.92]
  •  : 2
  • ISO/TC 131/SC 4
    23.100.40 
  • RSS обновления

Жизненный цикл

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)