ISO 21307:2017
p
ISO 21307:2017
63773
Indisponible en français

ISO 21307:2017 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are:

- single low-pressure fusion jointing procedure;

- dual low-pressure fusion jointing procedure;

- single high-pressure fusion jointing procedure.

ISO 21307:2017 takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.


Informations générales 

  •  : Publiée
     : 2017-12
  •  : 3
  •  : ISO/TC 138/SC 4 Tubes et raccords en matières plastiques pour réseaux de distribution de combustibles gazeux
  •  :
    75.200 Équipement de transport du pétrole, des produits pétroliers et du gaz naturel
    93.025 Systèmes externes d'adduction d'eau
    23.040.20 Canalisations en matières plastiques
    23.040.45 Raccords en matières plastiques

Acheter cette norme

fr
Format Langue
std 1 92 PDF
std 2 92 Papier
  • CHF92

Cycle de vie

Vous avez une question?

Consulter notre FAQ

Service à la clientèle
+41 22 749 08 88

Horaires d’ouverture:
De lundi à vendredi - 09:00-12:00, 14:00-17:00 (UTC+1)