Reference number
ISO 16063-11:1999
International Standard
ISO 16063-11:1999
Methods for the calibration of vibration and shock transducers — Part 11: Primary vibration calibration by laser interferometry
Edition 1
1999-12
Preview
ISO 16063-11:1999
24951
No disponible en español
Publicado (Edición 1, 1999)
Esta publicación se revisó y confirmó por última vez en 2021. Por lo tanto, esta versión es la actual.

ISO 16063-11:1999

ISO 16063-11:1999
24951
Idioma
Formato
CHF 151
Convertir Franco suizo (CHF) a tu moneda

Resumen

This part of ISO 16063 specifies the instrumentation and procedure to be used for primary vibration calibration of

rectilinear accelerometers (with or without amplifier) to obtain magnitude and phase lag of the complex sensitivity

by steady-state sinusoidal vibration and laser interferometry.

It is applicable to a frequency range from 1 Hz to 10 kHz and a dynamic range (amplitude) from 0,1 m/s2 to

1 000 m/s2 (frequency-dependent).

These ranges are covered with the uncertainty of measurement specified in clause 2. Calibration frequencies lower

than 1 Hz (e.g. 0,4 Hz, which is a reference frequency used in other International Standards) and acceleration

amplitudes smaller than 0,1 m/s2 (e.g. 0,004 m/s2 at 1 Hz) can be achieved using Method 3 specified in this part of

ISO 16063, in conjunction with an appropriate low-frequency vibration generator.

Method 1 (fringe-counting method) is applicable to sensitivity magnitude calibration in the frequency range 1 Hz to

800 Hz and, under special conditions, at higher frequencies (cf. clause 7). Method 2 (minimum-point method) can

be used for sensitivity magnitude calibration in the frequency range 800 Hz to 10 kHz (cf. clause 8). Method 3

(sine-approximation method) can be used for magnitude of sensitivity and phase calibration in the frequency range

1 Hz to 10 kHz (cf. clause 9).

Methods 1 and 3 provide for calibrations at fixed acceleration amplitudes at various frequencies. Method 2 requires

calibrations at fixed displacement amplitudes (acceleration amplitude varies with frequency).

Informaciones generales

  •  : Publicado
     : 1999-12
    : Norma Internacional confirmada [90.93]
  •  : 1
     : 27
  • ISO/TC 108
    17.160 
  • RSS actualizaciones

Ciclo de vida

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia